DIGITECH JAMMAN SOLO MANUAL PDF

There are 99 memory pressed. The STORE button will also be lit, indicating the phrase must be stored to memory to be recalled later. Overdubs can only be recorded to Loop phrases and not to Single phrases. If a phrase has had the tempo changed, it must first be stored to memory before overdub recording can proceed. Note that the JamMan Solo will convert stereo signals to mono when recording. Page 27 Time Signature Select a new memory location.

Author:Faelkree Gardalabar
Country:Montserrat
Language:English (Spanish)
Genre:Environment
Published (Last):16 December 2019
Pages:333
PDF File Size:8.55 Mb
ePub File Size:6.93 Mb
ISBN:504-1-86755-675-5
Downloads:44539
Price:Free* [*Free Regsitration Required]
Uploader:Samukasa



Page 8: Quick Start Quick Start 1. Make Connections 1. Page 9 Quick Start 2. Page 10 Quick Start 4. Adjust the Recording Level Play your guitar or sing into the mic at the level you will be recording.

Page 11 Quick Start 6. Loop Level Knob Controls playback level of recorded loops. Rhythm Level Knob Controls the level of the rhythm guide track. Page 14 Guided Tour - Front Panel Page 15 Guided Tour - Front Panel Press and hold this footswitch for two seconds to undo the last overdub.

When LOOP is lit the phrase will play back in an endless loop. Accepts low impedance dynamic or self powered condenser microphones. Page 17 Guided Tour - Rear Panel 5. See pages 35 and 36 for more information about the FS3X Footswitch. Page 22 Recording with the Aux Input 7. Note: The minimum loop length is 3. Page Recording Overdubs Recording Overdubs Once a loop phrase is recorded, you can add overdubs over the top of it. Overdubs can only be recorded to Loop phrases and not to Single phrases.

If a phrase has had the tempo changed, it must first be stored to memory before overdub recording can proceed. If you change your mind after undoing something, you can redo it. Note : Changing loops or plugging into a computer via USB discards any unstored changes. Setting the tempo in an empty loop memory location automatically starts playing the rhythm guide track Rhythm Level must be turned up to hear it.

These two Stop Modes are called Stop and Finish. To change Stop Modes, follow these steps: 1. Page Changing Loop Tempo Changing Loop Tempo Once a loop phrase is recorded, you can speed up or slow down the playback of the phrase without changing its pitch. Once a phrase has had the tempo changed, it must first be stored to memory before any overdubs can be added. Single phrases are designed to play through only once and stop. All phrases are recorded as loops first but they can be changed to a Single if desired and can always be changed back to Loops later without harming the phrase.

A Time Signature must be set up prior to recording in a memory location. Once a phrase has been recorded, Time Signature cannot be changed. To set the Time Signature, follow these steps: 1. To delete a loop from a memory location, follow these steps: 1. Press the button. The Erase Loops procedure only erases JamMan loop data. All other data and files on the card are left untouched. The Format Card procedure erases all data and files on the CompactFlash card. The card must be formatted before the JamMan can use it.

DOWN Selects the next lower memory location. Mode Switch Turns the Auto Record feature on and off. Page 43 9 VAC 1. Specifications are therefore subject to change without notice.

This manual is also suitable for: Jamman.

RSN311W64 DATASHEET PDF

JamMan Solo XT

.

ANTHARMUKHAM NOVEL BY YANDAMURI PDF

Digitech JamMan Solo Bedienungsanleitung

.

Related Articles