More A The strip shall be furnished cold rolled spheroidized annealed, soft annealed, intermediate hardness, or full hard, as specified. The heat or cast analysis shall conform to that specified requirement. Hardness test and bend test shall be made to conform to the requirements specified.
|Published (Last):||10 March 2019|
|PDF File Size:||10.75 Mb|
|ePub File Size:||10.13 Mb|
|Price:||Free* [*Free Regsitration Required]|
Full Description 1. Strip is classified as product that is 0. The maximum of the specified carbon range is over 0. It is furnished in the following types as specified: 1. It is normally produced to give the lowest maximum Rockwell hardness for each grade. It is produced to a maximum Rockwell hardness. It is produced to specified Rockwell hardness ranges, the maximum being higher than obtained for the annealed type.
It is produced to minimum Rockwell hardness requirements, which vary with grade, microstructure and gauge. Full hard can be produced with either a pearlitic or spheroidized microstructure or a mixture of both. The minimum hardness should be established between the consumer and the producer. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other.
Combining values from the two systems may result in non-conformance with the standard. The metric portions of the tables herein list permissible variations in dimensions and mass see Note 1 in SI metric units. The values listed are not exact conversions of the values listed in the inch-pound tables but instead are rounded or rationalized values.
However, under SI the preferred term is mass.
Want this as a site license? Changes from the previous issue A redline edition is available for this document, with all changes visible. Ask Document Center Inc. Scope 1. Strip is classified as product that is 0. The maximum of the specified carbon range is over 0. It is furnished in the following types as specified: 1.